最近有一些玩家表示,紳藍彈簧四階會有軸心錯位卡死的情形發生,其實在錯位的當下就可以馬上處理,完全不須全部拆開喔。

Sometimes the core alignment would miss due to the flexable spring structure , it can be fixed immediately without taking apart the cube .

如圖,軸心錯位,只剩下這個方向可轉(請注意,此時有貼LOGO的中心角位於上方)

As shown in the photo , there is only one direction left that could be twisted forward and backward of the half cube.


此時稍微撥開轉動層,會看到應該位於正中間的螺絲頭,已經不在正中間了(這就是中心錯位卡死,因為有彈簧伸縮容錯特性,所以偶爾還是有可能會發生錯位現象)

If we push aside of the middle parts , we should see the screws in the center parts missed aligned , so now we just need to adjust the screws to the right positions. 


如圖,如轉動"含中心LOGO"的上半部,會發現中心會跟著轉動,如轉動下半部則否,此時我們就是要用力抓著"不會跟著轉動"的下半部,然後轉動上半部來把錯位的螺絲頭歸位,如果順時針轉不進去,就換逆時針轉,直到雙手感覺到"喀"一下,這樣就是轉進去定位區了

 

If we twist the upper half of the cube and see the middle layer twisted with the outer layer , just hold the other half TIGHTLY , and twist the upper half to make the inner parts align to the center position again .
If you couldn't make it when twisting clockwise , try counter clockwise . You can feel a "Click!" and see the screws going back into the center position.

 
檢查一下,沒錯,金色的螺絲頭已經回到方塊的正中央了,這個時候試著轉動原本轉不動的方向,應該已經可以轉動了對吧?

以上就是關於四階中心錯位的應急處理介紹,如有任何問題,也歡迎來信詢問指教,謝謝!!

小丸愛設計