紳藍四階軸心錯位處理

作者 - 五尾 | 最後更新：2022-06-23, 上午10:08

最近有一些玩家表示，紳藍彈簧四階會有軸心錯位卡死的情形發生，其實在錯位的當下就可以馬上處理，完全不須全部拆開喔。

Sometimes the core alignment would miss due to the flexable spring structure , it can be fixed immediately without taking apart the cube .

如圖，軸心錯位，只剩下這個方向可轉(請注意，此時有貼LOGO的中心角位於上方)

As shown in the photo , there is only one direction left that could be twisted forward and backward of the half cube.

此時稍微撥開轉動層，會看到應該位於正中間的螺絲頭，已經不在正中間了(這就是中心錯位卡死，因為有彈簧伸縮容錯特性，所以偶爾還是有可能會發生錯位現象)

If we push aside of the middle parts , we should see the screws in the center parts missed aligned , so now we just need to adjust the screws to the right positions.

如圖，如轉動"含中心LOGO"的上半部，會發現中心會跟著轉動，如轉動下半部則否，此時我們就是要用力抓著"不會跟著轉動"的下半部，然後轉動上半部來把錯位的螺絲頭歸位，如果順時針轉不進去，就換逆時針轉，直到雙手感覺到"喀"一下，這樣就是轉進去定位區了

If we twist the upper half of the cube and see the middle layer twisted with the outer layer , just hold the other half TIGHTLY , and twist the upper half to make the inner parts align to the center position again .

If you couldn't make it when twisting clockwise , try counter clockwise . You can feel a "Click!" and see the screws going back into the center position.

檢查一下，沒錯，金色的螺絲頭已經回到方塊的正中央了，這個時候試著轉動原本轉不動的方向，應該已經可以轉動了對吧?